PE60_2

Readout electronics

PE60_2 for cooled BTCCD Sensor S11850, top
PE60_2 for cooled BTCCD Sensor S11850, top
PE60_2 for cooled BTCCD Sensor S11850, side
PE60_2 for cooled BTCCD Sensor S11850, side
PE60_2 for cooled BTCCD Sensor S11850, bottom
PE60_2 for cooled BTCCD Sensor S11850, bottom
PE60_2 for CMOS Sensor S11639
PE60_2 for CMOS Sensor S11639
PE60_2 for cooled InGaAs Sensor G1147x with TEC-Control
PE60_2 for cooled InGaAs Sensor G1147x with TEC-Control

The powerful PE60_2 operation electronics for line and image sensors is especially suited for high speed, process control and multichannel applications. Its generously dimensioned components enable the control of extensive periphery, complex internal calculations and tailored sensor readout.

Supported sensors

  • S837x, S11639, S13496, … (CMOS)
  • S838x, … (NMOS)
  • G13913 (InGaAs mini)
  • G11620, G92xx, … (uncooled InGaAs)
  • G1147x, G11620, G92xx, … (cooled InGaAs)
  • S10140, S10420, S11071,  S1115x, S7030, … (BTCCD)
  • S10141, S11511, S11850, S1325x, S7031, … (cooled BTCCD)
  • Others on request

Specifications

Electrical parameters

  • 32 bit, 252 MHz RISC Processor
  • Power Supply via USB or 5 V external
  • Analog-Digital-Conversion: 16 bit, up to 10 MS/s* with programmable gain and offset
  • JETI Universal Sensor Connector via 16-pin flat-ribbon-cable
  • Fast and low jitter trigger input and output, TTL compatible
  • Shutter/Lamp control output, firmware configurable
  • Flashlamp control with programmable length and interval timing
  • Stabilized 5 V Output
  • 8 GPIO-Pins, 3 Analog Inputs (12 Bit, 18 MS/s)*

Firmware

  • Continuous, 2D-Image and vertical multichannel measurement modes
  • Dark counts, reference counts, transmission, absorbance, (pixelwise or in wavelength steps with pixel wavelength fit up to 4th order)
  • Readout configuration: Averaging, Oversampling, Offset, Gain, Pixelrange, Pixelbinning
  • SCPI like Control Syntax, similar on all JETI electronics
  • Windows DLLs

Communication interfaces

  • USB-HighSpeed (480 Mbit/s, virtual COM Port)*
  • LV-TTL UART (25 MBaud, 8N1)*
  • SPI (50 Mbit/s, Master/Slave) *
  • 10/100 Ethernet LAN onboard (optional)

TEC-add-on-Board

  • High Power TEC driver up to 10 V, 3.5 A and <10 mK accuracy
  • Regulation Parameters programmable via PC-Software

Mechanical dimensions

  • 70 x 70 x 20 mm³

*maximum theoretical speed, practical values are application specific

Downloads

Firmware

Please contact us for the latest firmware version.

Please note, these drivers are only necessary for Windows 7/8/8.1.

Block diagram

Block diagram PE60_2
Your request