PE6000

Line array readout electronics


The PE6000 is a USB 3.2 SuperSpeed spectrometer electronic for highest speed applications. It enables 10MHz sensor clock with continuous data output signal, which equals 34000 Spectra/s for 256-pixel sensors. It's ideally featured for ultra highspeed spectral measurements with a very small form factor, low power demand and economic price.

Supported sensors
  • G11620 series (InGaAs)
  • S11639/S13496/S165xx series (CMOS- planned)
  • G14714 series (InGaAs - planned)
  • Others on request
PE6000 c
Electrical parameters
  • FGPA for exact timing and nanosecond jitter readout, 200 MHz 32-bit ARM core MCU for configuration and additional features
  • Continuous 10 MS/s 16-bit Data-Rate, ADC with programmable offset and gain
  • Trigger-In and -Out SMA-connector
  • Power supply via USB or external 6–28 V
  • USB-PD 3 A / 5 V profile supported
  • 3 user configurable digital-outputs for status LEDs
  • Stabilized 5 V Output
  • External or sensor integrated temperature sensor, values integrated in spectral data-stream
  • < 2.5 W power demand in full speed data streaming mode
Communication Interfaces
  • USB 3.2 Gen 1 compliant communication interface with up to 5 Gbit/s
Sensor compatibility
  • Compatible with multiple Hamamatsu image-line sensors
  • Compatible with IBSEN I-MON spectrometers
Firmware
  • Raw sensor signal output with programmable frame size
  • Spectral data including header files with nanosecond timestamp, trigger and temperature information, allows exact event tracking
  • Sensor type, pixel count and sensor gain programmable
  • SCPI like Control Syntax, similar on all JETI electronics
  • Windows DLLs
  • Plug & Play evaluation software for an easy start into custom projects
  • Possibility of in-field programming and firmware update via USB by integrated bootloader
TEC-add-on-Board
  • Highly efficient TEC driver up to 4 V, 3 A and <10 mK accuracy
  • Constant current source with advanced dimming features up to 2 A for LED’s etc.
  • LiPo Battery supply and charger
  • TEC-S Add-on board with LED/SLED/LASER driver and thermal regulation available
Mechanical dimensions
  • 56 x 58 x 14 mm³
  • Customer specific board shapes and adaptions on request
Documents
Datasheet
iconPDFPE6000 (509.15 KB) 
Documentation
Manuals
Software
Software JETI VersaSpec

JETI VersaSpec software is supplied on a USB drive with every JETI OEM spectrometer. If you need this software again, please contact our support team.

JETI SDK
JETI SDK
iconZIPJETI SDK Version 4.8.10 (5.97 MB)UPDATED 
iconPDFJETI SDK Changelog (156.75 KB) 
Firmware
Firmware
iconZIPFirmware PE6000 (1.43 MB) 
sdcm4 blockdiagramm
Block diagram hier noch von SDCM4